Magical Firefly Auto Mirror - baby in-sight - User Manual
←
→
Page content transcription
If your browser does not render page correctly, please read the page content below
63013
baby in-sight
®
Magical Firefly Auto Mirror
Keep these instructions for
future reference as they
contain important information.
Adult installation required.
Accessories not included.
birth+ User ManualMirror Features Remote Features
Front View
Top View C Bottom View
B
G
D
E
F
H
C Remote Transmitter
D Entertaining Mode
E Soothing Mode
F Volume
A G Visor Clip
H Battery Compartment
A Power button
Important: For optimum performance, ensure the remote has an unobstructed
B Power indicator light visual path to the mirror.
1 2Operating Mirror Operating Mirror, continued
Auto Shut-Off Battery Conservation
Remove Demo Tab To help conserve battery life, the mirror automatically shuts off after 1 hour of
The mirror is equipped with a “demo mode” feature. Before using the mirror, inactivity. The power indicator light will turn off and mirror cannot be activated
pull out the plastic demo tab located on the back of the battery box and by the remote during this time. To reactivate, press button on mirror. Power
discard it for normal operation. indicator light will appear.
Important: The mirror includes 3 “AA” batteries for in-store demonstration
Manual Shut-Off
only. Battery life may be impaired. Replace mirror batteries with 3 new “AA”
Press and hold button for 3 seconds. Power indicator light will turn off.
alkaline batteries (not included ) for normal use. Remote requires 1 “CR2032”
coin cell battery (not included).
1. Press button on front of mirror. Power indicator light will appear. The
button on the front of the mirror must be pressed in order to operate
remote control and mirror features.
2. Press desired mode on remote control:
Soothing Mode
a. Press button on remote once to activate soothing mode. Press again
to stop.
NOTE: Soothing mode stops automatically after approximately 12 minutes.
Press button again to restart.
Entertainment Mode
b. Press button on remote once to activate entertainment mode. Press
again to stop.
NOTE: Entertainment mode stops automatically after approximately 12
minutes. Press button again to restart.
Important: For optimum performance, ensure the remote has an unobstructed
visual path to the mirror.
3 4Battery Installation Battery Installation, continued
Remote: Mirror:
Mirror
• Loosen the screw in the battery compartment Battery Remove Demo Tab: The mirror is equipped with
door with a Phillips head screwdriver. Remove Door a “demo mode” feature. Before using the mirror,
the battery compartment door. pull out the plastic demo tab and discard it for
normal operation.
• Correctly insert 1 “CR2032” coin cell battery with
the polarity shown in battery compartment. Important: The mirror includes 3 “AA” alkaline
batteries for in-store demonstration only. Battery
• Replace the battery compartment door and life may be impaired. Replace mirror batteries
Remote tighten the screw with a Phillips head
Battery with 3 new “AA” alkaline batteries (not included)
Door screwdriver. Do not overtighten. PULL for normal use.
Important: If the mirror does not respond to the remote, it does not necessarily Hint: Remove the mirror from the seat back prior to replacing the batteries.
mean that the battery power in the remote is low. Check the orientation of the • Loosen the screw in the battery compartment door with a Phillips head
batteries in the battery compartments to make sure they are properly installed. screwdriver. Remove the battery compartment door.
• Correctly insert 3 “AA” batteries with polarity shown in battery compartment.
Hint: We recommend using alkaline batteries for longer battery life.
• Replace the battery compartment door and tighten the screw with a Phillips
head screwdriver. Do not overtighten.
Important: Under normal use conditions, the batteries in the mirror will
require replacement more often than the battery in the remote. When the
mirror’s music becomes faint, it’s time to replace the batteries in the mirror.
5 6Battery Safety Information ! CAUTION
Always verify that the mirror is properly secured on the seat
CR2032 back, head restraint or tether anchor. Check frequently.
Lithium Battery
3V
Shown Actual Size
! WARNING
Prevent strangulation or entanglement. Never place or
attach to a crib. Never add strings or ties to the product.
1.5V x 3 Never leave child unattended.
AA (LR06)
Shown Actual Size
Important Safety Precautions:
Keep mirror out of baby’s reach and direct sunlight. Always carefully follow
In exceptional circumstances, batteries may leak fluids that can cause a chemical
burn injury or ruin the remote or the mirror. To avoid battery leakage: car seat manufacturer’s directions for correct installation and position of a
• Do not mix old and new batteries or batteries of different types: alkaline, child safety seat.
standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated in battery compartments. To Clean:
Wipe the mirror with a soft, damp cloth. Fabric is surface washable with a
• Remove batteries during long periods of non-use. Always remove exhausted
batteries from the remote and mirror. Dispose of batteries safely. Do not damp cloth and mild soapy water. Do not submerse mirror in water.
dispose of this product in a fire. The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the remote and mirror before charging.
• If rechargeable batteries are used, they are only to be charged under
adult supervision.
7 8Mirror Features Attaching Mirror
Rear View I
D-Ring Clip
3
J Strap
K Adjustable
Stand
L
M Clamp
Back Seat Head Restraint
I D-Ring • Raise head restraint.
• Insert clamp underneath head restraint.
J Adjustable Stand • Wrap adjustable stand over top of head restraint.
K Battery Compartment • Bend clamp upward to conform to head restraint.
• Attach strap’s clip to D-Ring.
N
L Fastener • Lower head restraint down to secure in place.
O • Tighten strap and rotate mirror to desired angle so your child is visible to driver
M Clamp in vehicle’s rear-view mirror.
N Strap
O Clip
9 10Attaching Mirror Attaching Mirror
Adjustable Stand
Adjustable
Fastener Stand
Clip
Fastener
Tether
Anchor
Clamp
Clamp
Tether Anchor Center Back Seat on Bench Seat
IMPORTANT: DO NOT ATTACH THIS PRODUCT TO YOUR VEHICLE’S TETHER ANCHOR • Position mirror on center of back seat.
IF YOUR CHILD SAFETY SEAT IS INSTALLED IN YOUR VEHICLE USING THIS ANCHOR. • Bend clamp to conform to top of seat back.
• Position mirror on seat back in front of tether anchor. • Squeeze clamp firmly to secure mirror in place.
• Insert clamp between seat back and rear deck of your vehicle. • Unfasten adjustable stand’s fastener, and tilt mirror to desired angle so your child is
• Bend clamp to conform to seat back shape. visible to driver in vehicle’s rear-view mirror.
• Attach clip to tether anchor and tighten strap.
• Unfasten adjustable stand’s fastener and tilt mirror to desired angle so your NOTE: If a tether anchor is accessible and not in use by your child safety seat, attach clip
child is visible to driver in vehicle’s rear-view mirror. to tether anchor and tighten strap. This will help increase the stability of mirror. If you own
a minivan, station wagon or sport utility vehicle (SUV), you may need a tether extender.
NOTE: The tether anchor attachment method is designed for sedan vehicles. If you own a Please visit BRICA® at brica.com or call 1.866.869.8257
minivan, station wagon or sport utility vehicle (SUV) and would like to use the tether anchor
attachment method, you may need a tether extender. Please visit BRICA® at brica.com or
call 1.866.869.8257
11 12Attaching Mirror FCC Note (United States Only)
Clip D-Ring
Strap This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the legal limits for a Class B
Adjustable
digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide
Stand
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
Clamp television reception, which can be determined by turning equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Front Head Restraint (for forward-facing children)
• Raise head restraint up. • Reorient or relocate the receiving antenna.
• Insert clamp underneath head restraint. • Increase the separation between the equipment and receiver.
• Wrap adjustable stand over top of head restraint. • Consult the dealer or an experienced radio /TV technician for help.
• Bend clamp upward to conform to the head restraint.
• Attach strap’s clip to D-Ring.
NOTE: Changes or modifications not expressively approved by the manufacturer
• Lower head restraint down to secure in place.
responsible for compliance could void the user’s authority to operate the equipment.
• Tighten strap and adjust the mirror so child can see themselves.
NOTE: This method is used for mounting mirror to back side of driver or front passenger
seat for entertaining forward-facing children.
13 14making together better™
Questions?
Retain this address for future reference.
USA
©2013 BRICA, Inc., 500 West 5th Street,
Suite 220, Charlotte, NC 28202
1.866.869.8257 • brica.com
Australia
CNP Brands, PO Box 8 Deer Park VIC 3023
1 300 667 137 • cnpbrands.com.au
Printed in ChinaYou can also read
